Disclaimer: You are runing the ""VFD Controller.EXE" at your own risk and no guarentees are given.

VFD PID Setup
PD013 set 08 to reset to factory settings
PD001 is set to 2
PD002 is set to 2
PD003 is set at 400Hz
PD004 is set at 400Hz
PD005 is set at 400Hz
PD006 is set to 3
PD008 is set to 220
PD009 is set to 15
PD010 is set to 8
PD011 is set to 120
PD070 is set to 0
PD071 is set to 20
PD072 is set at 400Hz
PD142 is set to 7
PD143 is set to 02
PD144 is set to 3000
PD163 is set to 1
PD164 is set to 1
PD165 is set to 3


Controller_VFD setup
1. Copy "Controller_VFD.EXE" to your Mach3 folder.
2. Either replace M3.m1s in the Mach3\macros\Mach3Mill folder or copy the contents to the existing M3.m1s file (Make a backup copy of the exsisting M3.m1s)
3. Either replace M4.m1s in the Mach3\macros\Mach3Mill folder or copy the contents to the existing M4.m1s file (Make a backup copy of the exsisting M4.m1s)
4. Either replace M5.m1s in the Mach3\macros\Mach3Mill folder or copy the contents to the existing M5.m1s file (Make a backup copy of the exsisting M5.m1s)

The spindle will run and stop via MDI and gcode "M3", "M4" and M5 calls and will get the speed from the "S" call eg. "M3 S20000"
The DLL controlls speed between 6000 and 24000RPM

This will not run the spindle from the "SPINDLE CW" toggle buttons